Sun-microsystems SG-XPCIE1FC-EM8-Z Manual de usuario descargar pdf (Pagina 35)

CHAPTER

Hardware Installation and Removal

This chapter describes the tasks required to install and remove the HBA. Refer to

your system installation or service manual for detailed instructions.

This chapter contains the following topics:

■ “Observing ESD and Handling Precautions” on page 9

■ “Installing the Hardware” on page 10

■ “Testing the Installation” on page 17

■ “Replacing the SFP+ Unit on the HBA” on page 24

■ “Removing the Hardware” on page 24

Observing ESD and Handling

Precautions

Caution – Damage to the HBA can occur as the result of careless handling or

electrostatic discharge (ESD). Always handle the HBA with care to avoid damage to

electrostatic sensitive components.

To minimize the possibility of ESD-related damage, use both a workstation antistatic

mat and an ESD wrist strap. You can get an ESD wrist strap from any reputable

electronics store or from Sun as part number #250-1007. Observe the following

precautions to avoid ESD-related problems:

■ Leave the HBA in its antistatic bag until you are ready to install it in the system.

■ Always use a properly fitted and grounded wrist strap or other suitable ESD

protection when handling the HBA, and observe proper ESD grounding

techniques.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Sin comentarios

Sun-microsystems SG-XPCIE1FC-EM8-Z Manual de usuario Pagina 35