Sun Microsystems X2100 Manual de usuario descargar pdf (Pagina 17)

Chapter 1 System Setup 1-7

1.4.3 Attaching the Slide-Rail Assemblies to the Rack

Use this procedure to install the slide-rail assemblies to the rack.

1. Position a slide-rail assembly in your rack so that the brackets at each end of the

slide-rail assembly are on the outside of the front and rear rack posts. See

FIGURE 1-4.

2. Attach the slide-rail assembly to the rack posts.

The method used to attach the slide-rails varies depending on the type of rack:

■ If your rack has threaded mounting holes in the rack posts, first determine

whether the threads are metric or standard, and then insert the correct mounting

screws through the slide-rail brackets and into the threaded holes.

■ If your rack does not have threaded mounting holes, insert the mounting screws

through both the slide-rail brackets and rack posts, and then secure them with the

caged nuts.

FIGURE 1-4 Slide-Rail Assembly Mounting to Rack Post

3. Repeat Step 1 and Step 2 for the remaining slide-rail assembly.

Slide-rail

assembly

Rack post

Slide-rail assembly

bracket on outside

of rack post

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 77 78

Sin comentarios

Sun Microsystems X2100 Manual de usuario Pagina 17