Sun-microsystems Netra 120 Manual de usuario descargar pdf (Pagina 116)

8-16 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001

If you delete all the users you have set up, you will no longer see the login prompt

when you go to the lom> prompt.

8.4.7 Specifying Permissions for a Named User

By default, all four levels of permission are available to each named user you set up.

● To limit users to a particular level of permission, type:

You can specify:

■ No parameters

This makes all four levels available to the named user.

■ All four parameters (for example, userperm cuar)

This also makes all four levels available to the named user.

■ One, two or three parameters

This makes only the parameter or parameters you specify available.

The parameters are:

■ c

This stands for “console permission”. It enables the named user to exit from the

lom> prompt to the Solaris prompt (as long as the Serial A/LOM port is shared

between the LOM and the console).

■ u

This stands for “user administration permission”. It enables the named user to

add and delete users and alter their permission levels by using the userperm

command.

■ a

This stands for “administration permission”. It enables the named user to change

the LOM device’s configuration variables (see Section 8.5, “Setting the LOM

Device’s Configurable Variables” on page 8-17).

■ r

This stands for “reset permission”. It enables the user you have named to reset

the server and to power it on and off using the LOM device.

lom> userperm username [c][u][a][r]

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 199 200

Sin comentarios

Sun-microsystems Netra 120 Manual de usuario Pagina 116