Sun-microsystems Gigabit Ethernet MMF/UTP Adapter Manual de usuario Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 122
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
Chapter 2 Installing the Adapter 19
3. Press the Attention button.
The power LED should blink about 10 times then remain a steady green light.
To Verify the ExpressModule Installation
1. Use the cfgadm command to verify the ExpressModule installation:
If the ExpressModule is properly installed and connected, you should see output
similar to the following:
2. Use the dladm show-dev command to verify that the link is up.
You should see output similar to the following:
# cfgadm
Ap_Id Type Receptacle Occupant Condition
pcie5 etherne/hp connected configured ok
# dladm show-dev
e1000g2 link: up speed: 1000 Mbps duplex: full
e1000g3 link: up speed: 1000 Mbps duplex: full
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 121 122

Comentarios a estos manuales

Sin comentarios