Sun-microsystems 2000E Manual de usuario descargar pdf (Pagina 28)

2-12 SPARCserver2000E Power SupplyInstallationManual—April1995

5. Install the bottom cover panel.

Position the panel Part No. 340-3190-xx and install 12 screws

Part No. 240-1372-xx to secure the panel to the cabinet. See Figure 2-11.g

Figure 2-11 Installing the Bottom Cover Panel

2.5.2.3 MainBusBarInstallation

Install the main bus bar Part No. 340-3136-xx to connect the top and bottom

power supply busses.

1. Orient the bus bar as shown in Figure 2-12.

2. Place the bus bar flush against the top and bottom power supplies so

holes in the tabs slide over all bolts on the supplies: eight on the top

supply and eight on the bottom.

3. Loosely install in the order given the following on each bolt: a flat washer,

a lock washer and a nut.

See Figure 2-12.

4. Loosely install four M6 screws through holes in the bus bar to secure the

bus bar to the top and bottom cover panels.

The screw Part No. is 240-2083-xx. See Figure 2-12.

5. Tighten all nuts and screws installed in Step 3 and Step 4.

Bottom cover panel

Part No. 340-2190-xx

Screws (12 places)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 53 54

Sin comentarios

Sun-microsystems 2000E Manual de usuario Pagina 28