Sun-microsystems Netra CP32x0 Manual de usuario descargar pdf (Pagina 42)

2-12 Netra CP32x0 SAS Storage Advanced Rear Transition Module HD User’s Guide • January 2009

2.6 Changing the OOS LED Color

The color of the Out-of-service (OOS) LED can be set to red or amber by moving

jumper JU1 to the appropriate position. Setting the jumper to the P1/P2 position

makes the OOS LED appear red. Setting the jumper to the P2/P3 position makes the

OOS LED appear amber. Amber (position P2/P3) is the default setting for the OOS

LED.

1. Remove the ARTM-HD from the chassis.

See Section 2.3, “Removing the ARTM-HD” on page 2-9.

2. Locate jumper JU1 on the board.

JU1 is located next to the Primary SAS connector.

FIGURE 2-6 Jumper setting for red OOS LED (P1/P2)

3. Set the jumper housing to the appropriate setting; P1/P2 for red, P2/P3 for

amber.

Jumper 1

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 65 66

Sin comentarios

Sun-microsystems Netra CP32x0 Manual de usuario Pagina 42