Sun-microsystems SunFastEthernet Adapte Manual de usuario descargar pdf (Pagina 26)

2-6 SunFastEthernetAdapter UserGuide—November1994

2.3 BootingFromSunFastEthernetDevices

To get information about valid SunFastEthernet device path names for your

machine use the show-devs command as shown in the following example:

Look for the be node in the device paths. For the preceding example, the device

boot path for the SunFastEthernet channel would be:

/io-unit@f,e0200000/sbi@0,0/qec@1,20000/be@0,0

Note – Servers must be setup prior to booting as indicated in the following

step. Refer to Chapter 3 for Solaris 1.x and Chapter 4 for Solaris 2.x.

To boot from the OPB ok prompt, type boot and then the device path. In this

example, board 0, slot 1:

<#0> ok show-devs

/io-unit@f,e0200000/sbi@0,0/qec@1,20000

/io-unit@f,e0200000/sbi@0,0/lebuffer@3,40000

/io-unit@f,e0200000/sbi@0,0/dma@3,81000

/io-unit@f,e0200000/sbi@0,0/lebuffer@0,40000

/io-unit@f,e0200000/sbi@0,0/dma@0,81000

/io-unit@f,e0200000/sbi@0,0/qec@1,20000/be@0,0

/io-unit@f,e0200000/sbi@0,0/lebuffer@3,40000/le@3,60000

/io-unit@f,e0200000/sbi@0,0/dma@3,81000/esp@3,80000

/io-unit@f,e0200000/sbi@0,0/dma@3,81000/esp@3,80000/st

/io-unit@f,e0200000/sbi@0,0/dma@3,81000/esp@3,80000/sd

/io-unit@f,e0200000/sbi@0,0/lebuffer@0,40000/le@0,60000

/io-unit@f,e0200000/sbi@0,0/dma@0,81000/esp@0,80000

/io-unit@f,e0200000/sbi@0,0/dma@0,81000/esp@0,80000/st

/io-unit@f,e0200000/sbi@0,0/dma@0,81000/esp@0,80000/sd

<#0> ok

<#0> ok boot /io-unit@f,e0200000/sbi@0,0/qec@1,20000/be@0,0

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 87 88

Sin comentarios

Sun-microsystems SunFastEthernet Adapte Manual de usuario Pagina 26