Sun-microsystems SunFastEthernet Adapte Manual de usuario descargar pdf (Pagina 79)

E-1

ConsoleMessages(Solaris1.x

Only)

The SunFastEthernet software can output the messages listed below. Each

message is accompanied by an explanation and/or workaround.

Some of the messages indicate normal operation of the product, while others

indicate an error condition. In the latter category, certain messages indicate a

transitory condition, while others indicate a condition fatal to the operation of

the SunFastEthernet device.

The device cannot find a 100 Mbps transceiver and is switching to 10 Mbps

mode.

An attempt was made to unload the driver when the interface was still up. Use

ifconfig be<num> down to bring the interface down before unloading the driver.

Cannot reset the device. This is most likely due to a bad device.

be<num>: Cannot find 100Mbit tcvr, using 10Mbit

be<num>: Cannot free unit -- still running

be<num>: Cannot reset

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 87 88

Sin comentarios

Sun-microsystems SunFastEthernet Adapte Manual de usuario Pagina 79